Difference between revisions of "Hardness Testers"

Hardness Testers (view source)

361 bytes added , 22:38, 9 February 2013

no edit summary

3,218

edits

@@ Line 1: / Line 1: @@
 [[Category:Measuring, Calibration]]{{Knoppen}}
-<noinclude><!------------------------------------------------
+[[File:Hardness Testers.gif|thumb|right|Hardness Testers]]
-* READ THIS FIRST
+'''Hardness Testers''' provide consistent results to homogeneous materials regardless of the magnitude of the test load.Also, this tester can continuously measure hardness of materials, from the softest to the hardest, using the same measurement.
-* Only edit this page if you can improve the content.
-* Improper use of this page will lead to permanent banning.
-* Please do not edit the sponsored link on the top right corner.
-* Please start editing this page after the /noinclude
-* -------------------------------------------------></noinclude>
+==Applications==
-This page is still empty. If you know something about this product, please share your knowledge with others.
+* Precision parts of airplanes, vehicles, etc.
+* Thin sheets and small parts that can not be measured by hardness tester.
+* Surface hardness and cross-section hardness distribution of surface hardened materials
+* Normal steel: hard plates, this sheets, steel pipe, wire, etc.
+* Special steel: Steel bar, deformed steel, wire, etc.
+* Stainless steel: thin sheets, pipe
+* Structural objects that is tanks, bridges, etc.
+* Cross-section hardness distribution of welded joints: hard plates used for shipbuilding, welding pipe