Difference between revisions of "Bearing Heaters"
(Created page with "Category:Heating{{Knoppen}} <noinclude><!------------------------------------------------ * READ THIS FIRST * Only edit this page if you can improve the content. * Improper ...") |
PurplePen19 (talk | contribs) |
||
| Line 7: | Line 7: | ||
* Please start editing this page after the /noinclude | * Please start editing this page after the /noinclude | ||
* -------------------------------------------------></noinclude> | * -------------------------------------------------></noinclude> | ||
[[File:Bearing Heaters_1.jpg|thumb|200px|right|Bearing Heaters]] | |||
[[File:Bearing Heaters_2.jpg|thumb|200px|right|Induction Bearing Heaters]] | |||
'''Bearing Heaters''' are very similar with [[Induction Heaters]] which are used for bearings and other objects allow precise setting of time or temperature to prevent premature bearing failures due to overheating. Temperature probe continuously measures and screen displays actual temperature. "Stand by" feature permits holding temperature at pre-set level for an indefinite time. Automatically demagnetizes work pieces after heating. Light and buzzer signal termination of heating/demagnetizing cycle. | |||
==Features== | |||
• Extend bearing life and cut operating cost by eliminating hammering and pounding to cold-mount bearings | |||
• Works on bearings, sprockets, gears, couplings, sleeves | |||
• Reduces risk to operator from flames, torches or oil baths | |||
• Demagnetizes bearings – easy to use, ready in minutes | |||
• Bearing capacity: 8” x 22” O.D. (32”OD with optional raising blocks) | |||
• All Bearing heaters are single phase units | |||
==Specifications== | |||
• Voltage: 440V (20 amps) | |||
• Standard Cross Bar: 1-1/4", 3" | |||
• Optional Cross Bar: 3/4", 1", 2" | |||
• Weight: 200 Lbs. | |||
==Videos== | |||
<youtube>GJM8dnd_ptg</youtube> | |||
<youtube>_QeifnLDxH0</youtube> | |||
Revision as of 21:23, 25 August 2012
Bearing Heaters are very similar with Induction Heaters which are used for bearings and other objects allow precise setting of time or temperature to prevent premature bearing failures due to overheating. Temperature probe continuously measures and screen displays actual temperature. "Stand by" feature permits holding temperature at pre-set level for an indefinite time. Automatically demagnetizes work pieces after heating. Light and buzzer signal termination of heating/demagnetizing cycle.
Features
• Extend bearing life and cut operating cost by eliminating hammering and pounding to cold-mount bearings • Works on bearings, sprockets, gears, couplings, sleeves • Reduces risk to operator from flames, torches or oil baths • Demagnetizes bearings – easy to use, ready in minutes • Bearing capacity: 8” x 22” O.D. (32”OD with optional raising blocks) • All Bearing heaters are single phase units
Specifications
• Voltage: 440V (20 amps) • Standard Cross Bar: 1-1/4", 3" • Optional Cross Bar: 3/4", 1", 2" • Weight: 200 Lbs.
Videos