Difference between revisions of "Compression Crushers"

From SolidsWiki
Jump to navigation Jump to search
(Created page with "Category:Particle Size Reduction{{Knoppen}} <noinclude><!------------------------------------------------ * READ THIS FIRST * Only edit this page if you can improve the ...")
 
 
(5 intermediate revisions by the same user not shown)
Line 7: Line 7:
* Please start editing this page after the /noinclude   
* Please start editing this page after the /noinclude   
* -------------------------------------------------></noinclude>
* -------------------------------------------------></noinclude>
[[File:Compression_Crushers.png.jpg|thumb|right|Compression Crusher Principle]]
 
'''Compression crushing''' is a type material reduction ([[Crushers |crushing]]) method that uses a compression force between two surfaces. The pressure between the plates makes the material shatter in too smaller particles.
==Used== 
 
*If the material is hard and tough
*If the material is abrasive 
*If the material is not sticky
*When the material will break cubically 
 
==Crusher types==
 
*[[Gyradisc Crushers]]
*[[Jaw Crushers]]
*[[Roll Crushers]]
*[[Hammer Crushers]]
==Other crushing methods==
*[[Impact Crushers]]
*[[Shear Crushers]]
*[[Attrition Crushers]]

Latest revision as of 03:50, 3 February 2012


Compression Crusher Principle


Compression crushing is a type material reduction (crushing) method that uses a compression force between two surfaces. The pressure between the plates makes the material shatter in too smaller particles.


Used

  • If the material is hard and tough
  • If the material is abrasive
  • If the material is not sticky
  • When the material will break cubically


Crusher types


Other crushing methods