3,218
edits
Difference between revisions of "Roller Gates"
Jump to navigation
Jump to search
no edit summary
| Line 9: | Line 9: | ||
==Types of Roller Gates== | ==Types of Roller Gates== | ||
There are two types of roller gates: the overflow type for use where the water depth is the same as the height of the gate slide; and the breastwall type where water is considerably deeper than the height of the gate and/or where complete closure of the opening is required. | There are two types of roller gates: the overflow type for use where the water depth is the same as the height of the gate slide; and the breastwall type where water is considerably deeper than the height of the gate and/or where complete closure of the opening is required. | ||
===Overflow Type=== | ===Overflow Type=== | ||
| Line 21: | Line 20: | ||
==Operation== | ==Operation== | ||
Roller gates are usually operated with threaded stems and manual or electric lifts. Single stems are used when the gate width does not exceed twice the height. [[Gates ]]that are very wide compared to their height should have tandem stems. Very tall gates may be equipped with tandem stems and traveling stem guides in order to keep the stem size, yoke and lift in an optimum cost range. Roller gates may also be cylinder operated; however, very tall or very wide gates requiring tandem cylinders are not recommended due to synchronization or alignment problems. Another way of operating gates is with a rope hoist . Close attention must be paid to closing friction loads since the gate may require a ballast to close against the operating head. A roller gate may also serve as a removable bulkhead using an overhead crane. Lifts may be mounted on the concrete structure and are available with pedestals or wall brackets. More commonly, there is no concrete structure above the gate opening. In this case, the lift or tandem lifts are mounted on a head frame which can be either attached to the structure or be attached to the extended slot assemblies . | Roller gates are usually operated with threaded stems and manual or electric lifts. Single stems are used when the gate width does not exceed twice the height. [[Gates]] that are very wide compared to their height should have tandem stems. Very tall gates may be equipped with tandem stems and traveling stem guides in order to keep the stem size, yoke and lift in an optimum cost range. Roller gates may also be cylinder operated; however, very tall or very wide gates requiring tandem cylinders are not recommended due to synchronization or alignment problems. Another way of operating gates is with a rope hoist . Close attention must be paid to closing friction loads since the gate may require a ballast to close against the operating head. A roller gate may also serve as a removable bulkhead using an overhead crane. Lifts may be mounted on the concrete structure and are available with pedestals or wall brackets. More commonly, there is no concrete structure above the gate opening. In this case, the lift or tandem lifts are mounted on a head frame which can be either attached to the structure or be attached to the extended slot assemblies . | ||
==Applications== | ==Applications== | ||