Rod Mills - Revision history

Admin at 11:45, 18 February 2013

2013-02-18T11:45:23Z

← Older revision		Revision as of 05:45, 18 February 2013
Line 1:		Line 1:
	[[Category:Particle Size Reduction]]{{Knoppen}}		[[Category:Particle Size Reduction]]{{Knoppen}}
	~~<noinclude><!------------------------------------------------~~
	* READ THIS FIRST * Only edit this page if you can improve the content.
	* Improper use of this page will lead to permanent banning.
	* Please do not edit the sponsored link on the top right corner. .
	* Please start editing this page after the /noinclude
	* -------------------------------------------------></noinclude>

	[[File:Rod Mills_1.jpg\|thumb\|200px\|right\|Rod Mills]]		[[File:Rod Mills_1.jpg\|thumb\|200px\|right\|Rod Mills]]
	[[File:Rod Mills_2.jpg\|thumb\|200px\|right\|Rod Mills Parts]]		[[File:Rod Mills_2.jpg\|thumb\|200px\|right\|Rod Mills Parts]]

	'''Rod Mills''' are similar with the [[Ball Mills]] xcept they use long rods for grinding media. The rods grind the ore by tumbling within the the mill, similar to the grinding balls in a ball mill. To prevent the conditions leading to rod charge tangling, the length to diameter ratio is maintained at 1.4 to 1.6. Rod mills accept feed up to about 50 mm (2 in.) and produce a product in the size range of 3000 to 270 mm (–4 to –35 mesh). Grinding action is by line contact between the rods extending the length of the mill. Rods tumble and spin in roughly parallel alignment simulating a series of roll crushers. This results in preferential grinding of coarse material and minimizes production of slimes.		'''Rod Mills''' are similar with the [[Ball Mills]] xcept they use long rods for grinding media. The rods grind the ore by tumbling within the the mill, similar to the grinding balls in a ball mill. To prevent the conditions leading to rod charge tangling, the length to diameter ratio is maintained at 1.4 to 1.6. Rod mills accept feed up to about 50 mm (2 in.) and produce a product in the size range of 3000 to 270 mm (–4 to –35 mesh). Grinding action is by line contact between the rods extending the length of the mill. Rods tumble and spin in roughly parallel alignment simulating a series of roll crushers. This results in preferential grinding of coarse material and minimizes production of slimes.

PurplePen19 at 14:51, 15 October 2012

2012-10-15T14:51:13Z

@@ Line 5: / Line 5: @@
 * Please do not edit the sponsored link on the top right corner. .
 * Please start editing this page after the /noinclude
 * -------------------------------------------------></noinclude>
-This page is still empty. If you know something about this product, please share your knowledge with others.

Mark: Created page with "Category:Particle Size Reduction{{Knoppen}}